English 35
02 Connections
Connecting Audio from External Components
OPTICAL : Connecting an External Digital Component
For components with digital optical audio signals such as a Cable Box/Satellite receiver (Set-Top Box).
Connect the Digital Input (OPTICAL) on the product to the Digital Audio Output of the external
digital component using a digital optical cable.
Press the FUNCTION button to select D.IN input.
The mode switches as follows : BD/DVD D. IN AUX iPod HDMI1 HDMI2 TUNER
NOTE
To see video from your Cable Box/Satellite receiver, you must connect it's video output to a TV.
This system supports Digital sampling frequencies of 32 kHz of higher from external digital components.This system supports Digital sampling frequencies of 32 kHz of higher from external digital components.
This system supports only DTS and Dolby Digital audio, MPEG audio which is bitstream cannot be supported.
AUX : Connecting an External Analog Component
For analog audio signal components such as a VCR.
Connect AUX IN (Audio) on the product to the Audio Out of the external analog component.
Be sure to match connector colors.
Press the FUNCTION button to select AUX input.
The mode switches as follows : BD/DVD D. IN AUX iPod HDMI1 HDMI2 TUNER
NOTE
You connect the Video Output jack of your VCR to the TV, and connect the Audio Output jacks of the
VCR to this product.
1.
2.
•
✎
1.
•
2.
•
✎
Optical Cable
(not supplied)
Audio Cable
(not supplied)
If the external analog component has only one
Audio Out, connect either left or right.
Set-Top Box
AUX
WhiteRed
OPTICAL
VCR
Attach the ferrite core (Large) as close to
AUX IN as possible with no loop of core
made on the audio cable.
HT-C9950W_XAA_0830.indd 35HT-C9950W_XAA_0830.indd 35 2010-08-30 10:14:132010-08-30 10:14:13
To Next Page
Loading...
