Samsung HT-D6730W - Speaker Components and Assembly

20 English
Connections
Installing the Speakers on the Tallboy Stand
Turn the Stand Base upside-down and connect it to
the Stand.
Insert small screws (4x20, For connecting Stand &
Stand Base) clockwise into the four holes marked
using a screwdriver as shown in the illustration.
CAUTION
When you use a torque screwdriver, be careful not
to put excessive force. Otherwise, it runs idle or
can be damaged. (torque screwdriver- below 15
kg.f.cm)
Insert the large screw (5x15, For connecting Stand
& Stand Base) clockwise into the hole on the rear of
the stand using a screwdriver.
Connect the upper Speaker to the assembled
Stand.
Insert another large screw (5x15, For connecting
Speaker & Stand) clockwise into the hole on the rear
of the speaker using a screwdriver.
This is the appearance after the speaker is installed.
Follow this steps to install other speaker.
1.
2.
!

3.
4.
5.
6.
Speaker Components
CENTER
SUBWOOFER
SPEAKER CABLE SURROUND
(L) (R)
SWA-5000
Wireless Receiver Module
TX Card
Speaker Cable (2EA)
STAND BASE
SCREW (4x20): 8EA
SCREW (5x15): 4EA
FRONT/FRONT TOP
(L) (R)
STAND
2
Stand
Stand Base
1
3
65
Stand
Speaker
4
HT-D6730W_XAA_1226.indd 20HT-D6730W_XAA_1226.indd 20 2011-12-26  5:45:392011-12-26  5:45:39