15
ENG
● CONNECTIONS
▪ Do not hang onto the installed unit and avoid any impact to the unit.
▪ Secure the unit firmly to the wall so that it does not fall off. If the unit falls off, it may cause
an injury or damage to the product.
▪ When the unit is installed on a wall, please make sure that children not pull any of
connecting cables, as it may cause it to fall.
▪ For the optimal performance in a wall mount installation, keep the speaker system at least
2 inches (5 cm) distant from the TV.
2 inches (5 cm) or more
5. This is the completion of the suggested wall mount
installation.
SEPARATED SPEAKER WALL MOUNT
You can use the wall mount bracket to mount this unit on a wall.
A
MAIN SET (RIGHT)
B
SPEAKER (LEFT)
D
HOLDER-SCREW
E
SCREW
K
SCREW
M
HOLDER-WALL-VERTICAL
N
ASSY COVER P-CAP MAIN
O
ASSY COVER P-CAP SPK
1. Fix the wall mount bracket on the desired position, with 2
screws (not provided).
2. Insert N and O vertically in the MAIN SET A and B,
respectively. Then, tighten screw E to the end of the
hole.
3. Insert D and K in this order into each of two center holes
(in the rear of each speaker assembly) as shown. Then,
tighten it.
• For separate type installations, two speakers require
cabling to the cradles' terminal tabs.
4. Then, fit the unit into the corresponding slots of the M
(Holder wall vertical). For secure installation, make sure
the mounting studs slide firmly down into the bottom of
the slots.
• Only the top side (part D) can be assembled when
installing speakers perpendicularly to the main set.
M
B A
O N
D
K
E
To Next Page
Loading...
