Samsung HW-H450 - Page 30

Detaching the Wall Mount
1. Pull the Soundbar upwards as shown in the figure
to separate it from the wall mount.
()= · Secure the unit firmly to the wall so that
it does not fall off. If the unit falls off,
it
may cause an injury or damage the
product.
•
For your safety, if you do not mount the
unit
on the wall, install it on a secure,
flat surface where it is unlikely to fall.
Using the Sound bar
with Wall Mount
[Detaching the Sound bar from the Wall Mount]
Attaching The Toroidal Ferrite Core To The Power Cord Of The Subwoofer
You can reduce noise caused by electromagnetic radiation by fitting the ferrite core to ·
the power cord
of your subwoofer.
.:::::
iS
D
"""'
J
--
,_.
[ i~ []
'-----'
1. Unlock and open the ferrite core.
2. Wind the power cable of your subwoofer around
the ferrite core twice. (Start winding 2 to 4 inches
away from the core).
• 3. Close the ferrite core by pressing it until it clicks.
• You can control
the Subwoofer/Treble or Bass volume. Press the EQUALIZER
WOOFER button. Then, use the 1+~~ , ..,..1 button to adjust the volume.
4