Network Setup
Internet Protocol Setup : Auto Setup
Network Test
Enter
Move
Return
Auto Setup
Manual Setup
LAN Connection for Static IP Environment
The procedures to set up the network using a static IP address are described below. You have to manually enter the IP address, subnet
mask, gateway, and DNS that are provided by your Internet Service Provider (ISP).
TV Rear Panel
LAN Cable
1
The LAN Port
on the Wall
1 Connect the [LAN] port on
the rear panel of the TV and
the LAN port on the wall
using the LAN cable.
TV Rear Panel
Modem Cable
IP Sharer
LAN Cable
The Modem Port
on the Wall
You can connect the LAN via a Sharer (Router).
The terminals (the position of the port and the type) of the external device may differ depending on the manufacturer.
If you are using a static IP address, your ISP will inform you of the IP address, subnet mask, gateway, and DNS. You must enter
these values to complete the network settings. If you do not know the values, ask your network administrator.
FortheinformationonhowtocongureandconnectaSharer(Router),refertotheowner’smanualforthecorrespondingproduct.
You can connect the TV to the LAN directly without connecting it through a Sharer (Router).
If you use an IP Sharer (IP Router) that supports DHCP, you can set up the device as either DHCP or static IP.
For the procedures to use a static IP address, ask your Internet Service Provider.
➣
➣
➣
➣
➣
➣
To Next Page
Loading...
Need help?
General