English-28
4.7 Modem Setup
If you want to setup Modem, please follow the instruction below.
• Select "Tone" or "Pulse" in Dial Method.
• Select the "Carrier Wait Time" ranged in 1~255 seconds
with the / buttons or numeric buttons.
• Select the "Carrier Present Time" ranged in 0.1~25.5 seconds
with the / buttons or numeric buttons.
• Select the "Carrier Loss Time" ranged in 0.1~25.5 seconds
with the / buttons or numeric buttons.
• Select Blank, 0, # or 9 in "Prefix" by using / buttons,
to specify your pre-dialing button for phone extension.
• Press ‘ENTER/OK’ to save Modem configuration if modified.
Exit without ENTER/OK button makes Modem Setup unchanged.
Installing the CI card
1. Purchase the CI CAM module by visiting your nearest dealer or by phone.
2. Insert the CI card into the CAM in the direction of the arrow until it fits.
3. Insert the CAM with the CI card installed into the common interface slot.
Insert the CAM in the direction of the arrow, right up to the end so that it is parallel with the slot.
4. Check if you can see a picture on a scrambled signal channel.
You can install the CAM anytime whether the TV is ON or OFF.
BN68-01007J-00Eng.indd 28BN68-01007J-00Eng.indd 28 2006-08-09 10:36:282006-08-09 10:36:28
To Next Page
Loading...
