Samsung LN-S2641D - Memorizing the Channels

English-16
Memorizing the Channels
Your TV can memorize and store all of the available channels for both “off-air” (antenna) and cable channels.
After the available channels are memorized, use the CH or CH buttons to scan through the channels.
This eliminates the need to change channels by entering the channel digits. There are three steps for memorizing channels:
selecting a broadcast source, memorizing the channels (automatic).
Selecting the Video Signal-source
Before your television can begin memorizing the available channels, you must specify the type of signal source that is connected to the
TV (i.e. an antenna or a cable system).
1. Press the MENU button to display the menu.
Press the  or  buttons to select “Channel”, then press the ENTER button.
2. Press the ENTER button select “Antenna”.
Press the  or  buttons to select “Air” or “Cable”, then press the
ENTER button.
Press the
EXIT button to exit.
Storing Channels in Memory (Automatic Method)
1. Press the MENU button to display the menu.
Press the  or  buttons to select “Channel”, then press the ENTER button.
2. Press the  or  buttons to select “Auto Program”, then press the ENTER button.
3. Press the  or  buttons to select the antenna connection, then press the
ENTER button.
Air: “Air” antenna signal. / Cable: “Cable” antenna signal. /
Air+Cable: “Air” and “Cable” antenna signals.
4. After all the available channels are stored, the “Auto Program” menu reappears.
Press the
EXIT button to exit.
Alternately, you can press the AUTO PROG. button on the remote control to bring up
the Auto Program menu.