4-20
4. Troubleshooting
4-3. Factory Mode Adjustments
4-3-1 Entering Factory Mode
To enter ‘Service Mode’ Press the remote -control keys in this sequence :
- If you do not have Factory remote - control
MUTEPower OFF 1 8 2 Power On
4-3-2 How to Access Service Mode
Using the Customer Remote
Turn the power off and set to stand-by mode
Press the remote buttons in this order; POWER OFF-MUTE-1-8-2-POWER ON to turn the set on.
The set turns on and enters service mode. This may take approximately 20 seconds.
Press the Power button to exit and store data in memory.
- If you fail to enter service mode, repeat steps 1 and 2 above.
Initial SERVICE MODE DISPLAY State
ADC
ADC Target
ADC Value
Option BYTE
ADJUST
W/B
W/B Movie
EPA standard
FBE3
VDEC
Scaler
Sharpness
PE
Sound
Dynamic Contrast
PDP Option
Expert Settings
Expert D-Settings
Expert Gray Scale
Expert C-Space
Expert Others
CHECKSUM
RESET
T-CRLAUSC-00xx
0050 6628 00CD 1510
Micom / VER. / Month/ Day / Year
- “T-PEONAUSC-1000” and “T-PEONASS-1000” are rmware.......
over version 2000 means Micronas FRC rmware.
Buttons operations withn Service Mode
Menu Full Menu Display/Move to Parent Menu
Direction Keys
/
Item Selection by Moving the Cursor
Direction Keys
/
Data Increase / Decrease for the Selected Item
Source
Cycles through the active input source that are connected to the unit
1.
2.
3.
4.
5.
6.
To Next Page
Loading...
