Alignment and Adjustments
1-3Samsung Electronics
1) Connect the measuring instruments as shown in Figure 1-7.
2) Set the DOLBY NR Switch off.
3) Measuring tape:
MTT-5512 (or equivalent: normal recording)
4) The input signals supply 400Hz 400mV into AUX IN of AMP (AUDIO OSC.)
1-2-3 To Adjust Recording Level
1
See diagram
for adjustment
locations
25 mV
L-CH: JSR1L and
R-CH: JSR1R to
the right and left
To Adjust
Standard
Remark
Pre-Setup
Item
Step
Pre-Setup
Condition
Connect to
JCW2 as in Figure
1-7 and read the
VTVM
Insert MTT-5512 into
Deck2, then press
REC button.
BIAS
Electric
current
Figure 1-7
Audio OSC.
Cassette Deck
Oscilloscope
AUX IN
SPK OUT
VTVM
IN
JCW2
IN OUT
NOTES
Figure 1-8 Adjustment location of Deck
To Next Page
Loading...
