Samsung MAX-C550 - System and Special Features

Samsung Electronics 3-7
The timer enables you to switch the system on or off at spe-
cific times.
Example: You wish to wake up to music every morning.
If you no longer want the system to be switched on or off auto-
matically, you must cancel the timer.
Before setting the timer, check that the current time is cor-
rect.
For each step, you have a few seconds to set the required
options. If you exceed this time, you must start again.
Switch the system on by pressing STANDBY/ON.
Press TIMER/CLOCK until TIMER is displayed.
Press ENTER.
Result:
ON TIME is displayed (instead of the equalizer symbols)
for a few seconds, followed by any switch-on time already
set; you can set the timer switch-on time.
Set the timer switch-on time.
a Set the hour by pressing the
/ buttons
.
b Press ENTER.
Result:
The minutes flash.
c Set the minutes by pressing the
/ buttons
.
d Press ENTER.
Result:
OFF TIME is displayed (instead of the equalizer sym-
bols) for a few seconds, followed by any switch-off time
already set; you can now set the timer switch-off time.
Set the timer switch-off time.
a Set the hour by pressing the
/ buttons
.
b Press ENTER.
Result: The minutes flash.
c Set the minutes by pressing the
/ buttons
.
d Press ENTER.
Result:
VOL XX is displayed, where XX corresponds to the vol-
ume already set.
Press DOWN and UP to adjust the volume level and
press
ENTER.
Result:
The source to be selected is displayed.
pressing the
/ buttons to select
the source to be played
when the system switches on .
If you select... You must also...
TAPE (cassette) Insert a recorded cassette in one of the
decks before setting the system to stand-
by.
TUNER (radio) a Press
ENTER.
b Select a preset station by
pressing the
/ buttons
.
CD (compact disc) Load one or more compact discs.
Press ENTER to confirm the timer.
Press STANDBY/ON to set the system to standby mode.
Result
: appears on the front panel display next to the time, indi-
cating the timer has been set. The timer automatically turns
the system on or off at a designated time.
If the timer switch on and off times are identical, the word ERROR
is displayed.
Timer Function
COUNT
RESET
7
8
9
5
6
1
2
3
4
1,9
2
3,4,5,6,7,8
After having set the timer, it will start automatically as shown
by the TIMER indication on the display. If you no longer wish
to use the timer, you must cancel it.
You can stop the timer at any time (system on or in standby mode).
To... Press TIMER ON/OFF...
Cancel the timer Once.
Result: is no longer displayed.
Restart the timer Twice.
Result
: is displayed again.
Cancelling the Timer

4,5,6,7
4,5,6,7
To set the timer function
You may use TUNING ALBUM or on the remote control
to adjust in step 4, 5, 6, 7.