Samsung MH035FPEA - Connecting the Assembly Cable

E-
9
ENGLISH
Connecting the Assembly Cable
INSTALLING THE INDOOR UNIT
The indoor unit is powered from the outdoor unit via the assembly cable.
1 Extend the assembly cable if necessary.
2 Open the front grille by pulling on the tabs on the lower right and left sides
of the indoor unit.
3 Remove the screw securing the connector cover.
4 Pass the assembly cable through the rear of the indoor unit and connect the
assembly cable such as figure.
➢ Each wire is labelled with the corresponding terminal number.
5 Pass the other end of the cable through the 65 mm hole in the wall.
6 Replace the connector cover, carefully tightening the screw.
7 Close the front grille.
8 For further details on how to plug the other end of the assembly cable into
the outdoor unit, refer to installation manual of the outdoor unit.
1(L) 2(N)
F1 F2
F12(N)1(L) F2
1
2
E
E
12
F1 F2
F1 F2
Indoor
unit
Outdoor
unit
Earth
terminal
Earth
terminal
MH026FPEA IM_E_20238 1/24/05 5:25 PM Page 9