19. Install the new drum in place. 20. Install the PCR cleaner assembly.
21. Clean the conductive grease off the left side (non gear)
end cap and replace with fresh grease. Replace the end cap
and four screws.
22. Install the PCR. Make sure that the PCR gear is on the cor-
rect side and that the shaft is in the PCR holder.
SAMSUNG ML 2250 • CARTRIDGE REMANUFACTURING INSTRUCTIONS
3232 West El Segundo Blvd., Hawthorne, California 90250 USA • Ph +1 424 675 3300 • Fx +1 424 675 3400 • techsupport@uninetimaging.com • www.uninetimaging.com
© 2009 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only. UniNet Imaging does not warrant downloaded information.
To Next Page
Loading...
