Samsung ML-2251N - Fuser Assembly Removal

5-11
Samsung Electronics
Disassembly and Reassembly
Service Manual
1. Before you remove the Fuser Ass’y, you should
remove:
-Rear Cover
2. Unplug the four connectors from the Main PBA
and SMPS, as shown below. Then remove the
four screws securing the Fuser Ass’y and
remove it.
3. Remove the two screws securing the Thermostat.
Then lift the Thermostat out.
4. Remove the two screws securing the Halogen
Lamp. Then take out the Halogen Lamp from
the Heat Roller, as shown below.
5. Remove four screws securing the Fuser Cover
and two screws securing the Guide Input to
dismantle the fuser unit..
Thermostat
Halogen Lamp
5.11 Fuser Ass’y
Fuser Cover
Claw
Fuser Ass’y