9.8 <
Troubleshooting>
Page Too Complex
Too complicated
data was sent to the
printer.
Simplify the page
layout and remove
unnecessary graphics
from your document.
If the message
persists, expand the
memory in your
printer. See
page 10.1.
Paper Jam 0
Open/Close Door
Paper has jammed
in the feeding area
of the tray.
Clear the jam. See
page 9.1 and
page 9.1.
Paper Jam 1
Open/Close Door
Paper has jammed
in the fuser area.
Clear the jam. See
page 9.3.
Paper Jam 2
Check Inside
Paper has jammed
in the paper exit
area.
Clear the jam. See
page 9.3.
Power Failure Power has turned off
then on and the
printer’s memory
has not been back
up.
The job which you
were trying to do
before the power
failure must be
completely re-done.
Press Cont Key
The paper size
specified in the
printer properties
does not match the
paper you are
loading.
Load the correct
paper and press
Stop
(ML-3050) or OK
(ML-3051N, ML-
3051ND)
Printing xxx
The printer is
printing jobs using
the displayed
language.
Complete your
printing.
Ready
The printer is on-line
and ready to printer.
Use your printer.
Ready Close Tray
1
The tray 1 is open
but there is paper in
the
multi-purpose
tray
.
Close the tray 1 to
clear the message.
Ready Close Tray
2
The
optional tray 2
is
open but there is
paper in the
multi-
purpose tray
.
Close the optional
tray 2 to clear the
message.
Ready IP Conflict
An IP address
conflicts with other
cards on the
network.
Contact your network
administrator and
choose an address
within your subnet
which will not conflict
with any other cards.
Message Meaning Suggested solutions
Ready Replace
Cart
The life of some
parts on the toner
cartidge ends.
Regardless of the
remaining toner, this
is warning message
showing that the toner
cartidge replacement
is needed as the parts
life is exhausted.
The toner cartidge is
at the end of its life
and the print quality
lowers, you need to
replace the cartridge
to new one.
Replace Toner This message
appears between
the Toner Empty
and Toner Low
status.
Replace the toner
cartridge with a new
one. See page 8.4.
Reset Now
The network card is
initializing.
Wait until the
message is cleared.
Restore
The printer settings
or network settings
are turning to their
default value.
Wait until restoring is
complete.
Self Diagnostic... The engine in your
printer is checking
some problems
detected.
Please wait a few
minutes.
Serial Error There is a problem
in your printer.
Unplug the power
cord and plug it back
in. If the problem
persists, please call
for service.
Sleeping
The printer is on
power save mode.
When data is
received, it switches
to on-line
automatically.
Toner Empty The toner cartridge
has run out. The
printer stops
printing.
Replace the toner
cartridge with a new
one. See page 13.5.
Toner Low The toner cartridge
is almost empty.
Take out the toner
cartridge and
thoroughly shake it.
By doing this, you can
temporarily
reestablish printing
operations.
Message Meaning Suggested solutions
To Next Page
Loading...
