18
GB
The timer enables you to switch the system on or off at specific times.
Example: You wish to wake up to music every morning.
If you no longer want the system to be switched on or off
automatically, you must cancel the timer.
Before setting the timer, check that the current time is correct.
For each step, you have a few seconds to set the required
options. If you exceed this time,
you must start again.
Switch the system on by pressing On/Standby ( ).
Press Timer/Clock until TIMER is displayed.
Press Program/Set.
Result
:ON TIME is displayed for a few seconds, followed by any switch-
on time already set; you can set the timer switch-on time.
Set the timer switch-on time.
a Set the hour by pressing Tuning and .
b Press Program/Set.
Result
: The minutes flash.
c Set the minutes by pressing Tuning and .
d Press Program/Set.
Result
: OFF TIME is displayed for a few seconds, followed by any
switch-off time already set; you can now set the timer switch-off
time.
Set the timer switch-off time.
a Set the hour by pressing Tuning and .
b Press Program/Set.
Result
: The minutes flash.
c Set the minutes by pressing Tuning and .
d Press Program/Set.
Result: VOL 10 is displayed, where 10 corresponds to the volume already set.
Press Tuning and to adjust the volume level and press
Program/Set.
Result
:The source to be selected is displayed.
Press Tuning and to select the source to be played when the
system switches on.
If you select... You must also...
TAPE (cassette) ; Insert a recorded cassette in the deck.
TUNER (radio) ;
•
Select the FM or AM frequency band by pressing
Tuning and .
•
Press Program/Set.
•
Select a preset station by pressing
Tuning and .
CD (compact disc) ; Load compact disc.
Press Program/Set to confirm the timer.
Press On/Standby to set the system to standby mode.
Result
:
is displayed to the middle right of the time, indicating that the timer has
been set. The system will switch on and off automatically at the required
times.
If the timer switch on and off times are identical, the word ERROR
is displayed.
After having set the timer, it will start automatically as shown by
the indication on the display. If you no longer wish to use the
timer, you must cancel it.
You can stop the timer at any time (system on or in standby mode).
To... Press Timer On/Off
Cancel the timer Once.
Result
: is no longer displayed.
Restart the timer Twice.
Result
: is displayed again.
Timer Function
To Next Page
Loading...
