GB
10
Your system is equipped with a clock which allows you to
turn your system on and off automatically.
You should set the clock:
When you first purchase the micro component system
After a power failure
After unplugging the unit
For each step, you have a few seconds to set the required
options. If you exceed this time, you must start again.
Switch the system on by pressing On/Standby ( ) .
Press Timer/Clock twice.
Result:
CLOCK is displayed.
Press Program/Set.
Result:
The hour flashes.
To... Press...
Increase the hours
Decrease the hours
When the correct hour is displayed, press Program/Set.
Result:
The minutes flash.
To... Press...
Increase the minutes
Decrease the minutes
When the correct time is displayed, press Program/Set.
Result: The clock starts and is displayed, even when the system is in
standby mode.
You can display the time, even when you are using another
function, by pressing Timer/Clock once.
You can use the Multi Jog to instead
/ button in step
4,6.
Setting the Clock
1
2
3
4
5
6
7
You can view the various functions available on your system.
Press the Demo button.
Result: The various functions available are listed in turn on the
display.
All these functions are described in detail in this booklet.
For instructions on how to use them, refer to the appropriate
sections.
To cancel this function, press Demo again.
2
1
Viewing the Various Functions on
Your System
On/Standby
AUX
Phones
Demo
Po
Surr
Sle
Mon
REC/Pause
CD Synchro
CD Repeat
TUNER/Band
Tuning Mode
C D
TAPE
F
R
O
N
T
L
O
A
D
I
N
G
M
E
C
H
A
N
I
S
M
Timer
On/Off
EQ/S.Bass
REV.
Mode
CD SYNC.
CD
Repeat
Program/
Set
Tuning
Mode
VOL.
Band
+10
Sleep
TAPE
Aux
Timer/
Clock
VOL.
Display PTY
RDS
4,6
1
3,5,7
4,6
2
MM-B9(GB) 5/17/03 11:27 Page 10
To Next Page
Loading...
