18
GB
19
GB
Always treat your cassettes with care; refer, if necessary, to
the section entitled “Precautions When Using Audio Cassettes”
on page 24.
Switch the system on by pressing ( ).
Open the cassette deck by pushing on the corner of the cover
marked PUSH EJECT ( ) until you hear a click and then releasing it.
Insert the pre-recorded cassette with the open edge of the tape
facing downwards.
Close the deck by pushing on it until it clicks into place.
To listen to... Press ...
Side A Tape ( ) button once.
Side B Tape ( ) button twice.
Result:
The cassette starts playing.
Press the
, or , button if necessary.
To... Press ...
Rewind the cassette
/
button.
Fast-forward the cassette / button.
When you have finished playback, press
button.
Your micro component system has three cassette playback
modes which enable you to listen to both sides of a cassette
automatically.
Press REV.MODE until the appropriate symbol is displayed.
When the display indicates... The micro component system plays
back...
One side of the selected cassette and
then stops.
One side of the cassette.
The other side of the cassette and then
stops.
Both sides of the cassette indefinitely until
you press stop.
Selecting the Cassette
Playback Mode
Listening to a Cassette
1
2
3
4
5
6
5
1
4
6
2,3
5
You can record a radio program of your choice.
You do not need to adjust the volume, as it has no effect on
the recording.
Switch the system on by pressing ( ) .
Insert a blank cassette in Deck.
Select the TUNER function by pressing TUNER/BAND.
Select the radio station that you wish to record by pressing
or button .
Press the CD SYNC/REC/PAUSE button.
Result:
REC is displayed and recording starts.
To stop recording, press button.
1
2
3
4
5
6
The direct recording mode enables you to start recording
with any track on the compact disc.
You do not need to adjust the volume, as it has no effect on the recording.
Switch the system on by pressing ( ) .
Insert a blank cassette in Deck.
Press the PUSH/EJECT button ( ) to open the cassette door,
insert a cassette, and then close the cassette door.
Insert the cassette with the safety tabs.
Recording a Radio Program
You can record a compact disc on a cassette in two different ways:
Synchronised recording
Direct recording
This feature enables you to synchronize the start of the
recording with the start of the disc or track of your choice.
Switch the system on by pressing ( ) .
Insert a blank cassette in Deck.
Press the PUSH/EJECT button ( ) to open the cassette door,
insert a cassette, and then close the cassette door.
Insert the cassette with the safety tabs.
Load a compact disc.
Press the OPEN/CLOSE button ( ) to open the CD door.
Insert a CD and press the OPEN/CLOSE button ( ) to close
the CD door.
Press the MP3-CD/CD(
√/»
) button.
Use the CD selection ( , ) buttons to select the desired song.
Press and hold CD SYNC/REC/PAUSE button.
When stopped, press the button to start the recording from the
first piece of music.
Press and hold CD SYNC/REC/PAUSE button during the play-
back of CD to start the recording from the first part of the music
being played.
To stop recording, press button.
Synchronised recording
1
2
3
4
5
6
1
2
Direct recording
Recording a Compact Disc
1
6
4
4
5
4
3
2
5
1
4
4
3
6
Load a compact disc.
Press the OPEN/CLOSE button ( ) to open the CD door.
Insert a CD and press the OPEN/CLOSE button ( ) to close
the CD door.
Press the MP3-CD/CD(
√/»
) button.
Use the CD selection ( , ) buttons to select the desired song.
Press the CD SYNC/REC/PAUSE button.
Result:
Recording will begin.
To stop recording, press button.
3
4
5
When playing a cassette, a counter is displayed to enable you
to take note of the counter value at the start of each track
and thus start playback at the beginning of the track to which
you wish to listen.
The counter is only displayed when a cassette is being played.
Before starting to record a cassette for which you wish to take note of
the counter values at the beginning of each track, reset the counter
by pressing COUNTER RESET.
Tape Counter
To Next Page
Loading...
