GB
6
Your system is equipped with a clock which allows you to turn
your system on and off automatically. You should set the clock:
When you purchase the Micro component system
After a power failure
After unplugging the unit
For each step, you have a few seconds to set the required
options. If you exceed this time, you must start again.
1 Switch the system on by pressing On/Standby.
2 Press Timer/Clock twice.
Result: CLOCK is displayed.
3 Press Program/Set.
Result: The hour flashes.
4 To... Press...
Increase the hours
Decrease the hours
5 When the correct hour is displayed, press Program/Set.
Result: The minutes flash.
6 To... Press...
Increase the minutes
Decrease the minutes
7 When the correct time is displayed, press Program/Set.
Result: The clock starts and is displayed, even when the
system is in standby mode.
You can display the time, even when you are using another
function, by pressing Timer/Clock once.
You can play 12 cm or 8 cm compact discs without an adapter.
1 Select the CD function by pressing CD on the front panel.
2 Open the compact disc compartment by pressing the
Open/Close ( ) button.
3 Place your disc in the compartment, with the label on the disc
facing upwards.
4 Close disc compartment by pressing the Open/Close ( )
button.
Result: The display indicates the number of tracks
on the disc.
5 Press the PLAY/PAUSE ( ) button.
Result: The first track on the disc plays and the track
number is displayed.
6 To stop playback temporarily, press the PLAY/PAUSE ( )
button.
Press PLAY/PAUSE ( ) again to continue playing
the disc.
7 To start playing Press...
at the beginning of...
The next track SKIP/SEARCH once
The current track SKIP/SEARCH once
The previous track SKIP/SEARCH twice
The track of your choice SKIP/SEARCH or
the appropriate number of times
8 To search through Press and hold down...
the tracks...
Forwards SKIP/SEARCH until you
reach the required point
Backwards SKIP/SEARCH until you
reach the required point
You are advised to turn the volume down before using
this function.
9 Press the STOP ( ) button when you have finished.
Setting the Clock
To Next Page
Loading...
