English - 14
CHECKING THAT YOUR OVEN IS OPERATING
CORRECTLY
The following simple procedure enables you to check that your oven is working correctly
at all times.
Open the oven door by pulling the handle on the right side of the door.
Place a glass of water on the turntable. Then, close the door.
1. Press the Microwave button.
2. Set the time 4 to 5 minutes by turning the Dial Knob and
press the Start/+30s button.
Result: The oven light comes on and the turntable starts
rotating.
1) Cooking starts and when it has finished the
oven beeps 4 times.
2) The end reminder signal will beep 3 times
(once every minute).
3) The current time is displayed again.
The oven must be plugged into an appropriate wall socket. The turntable must be
in position in the oven. If a power level other than the maximum is used, the water
takes longer to boil.
SETTING THE TIME
Your microwave oven has an inbuilt clock. When power is supplied, “:0”, “88:88” or
“12:00” is automatically displayed on the display.
Please set the current time. The time can be displayed in either the 12-hour notation.
You must set the clock:
•
When you first install your microwave oven
•
After a power failure
Do not forget to reset the clock when you switch to and from summer and winter
time.
1. To display the time in the...
12-hour notation
Press the Clock button.
2. Turn the Dial Knob to set the hour.
3. Press the Clock button.
4. Turn the Dial Knob to set the minute.
5. Press the Clock button.
MS23F301TAW_PE_DE68-04273B-00_EN.indd 14 2014-08-28 �� 3:15:55
To Next Page
Loading...
Need help?
General
