20
Field specication setting mode of wired remote controller
Use of eld specication setting mode
Data
Main menu
Sub-menu
1. If you want to use the eld specication setting mode for your wired remote controller, press the Set and [∨]
buttons at the same time for more than 3 seconds.
2. Refer to the list of eld specication for your wired remote controller on the next page, and select the desired menu.
Using the [∧]/[∨] buttons, select a main menu number and press the [＞] button to enter the sub-menu setting
screen.
Using the [∧]/[∨] buttons, select a sub-menu number and press the [＞] button to enter data setting screen.
When you enter the setting stage, the current setting value will be displayed.
Refer to the chart for data settings.
Using the [∧]/[∨] buttons, change the setting value and press the Set button to save the setting value. Setting value
will be displayed when it is saved.
Press the [＜] button to move previous setting value.
While conguring the sub manu setting, press the ESC button to exit to normal menu.
• While conguring the setting, press the ESC button to exit to the sub-menu setting screen without saving your
changes.
• When you don't enter any buttons for more than 3 minutes, you will be back to normal mode.
NOTE
DVM HT_HE RC-EU_IM_EN_DB68-03973A-06.indd 20 2017-05-25 오후 4:18:32
To Next Page
Loading...
Need help?
General
