What does C-d0 mean on my Samsung NE63 811?
If your Samsung Range displays 'C-d0', it means the control key was shorted for 1 minute. Press OFF, and then restart the oven. If the problem persists, disconnect all power to the range for at least 30 seconds and then reconnect the power.
Why my Samsung Ranges oven will not turn on?
If your Samsung Range oven will not turn on, there are several potential causes: * The range may not be completely plugged into the electrical outlet. Ensure the electrical plug is correctly inserted into a properly grounded outlet. * A fuse in your home may be blown, or a circuit breaker may have tripped. Replace the fuse or reset the circuit breaker. * The oven may be too hot. Allow the oven to cool down. * Power outage. Check to see if the house lights will turn on. If necessary, call your local electric company for service.
Why Samsung NE63 811 Ranges surface units will not maintain a rolling boil?
If the surface units on your Samsung Range won't maintain a rolling boil or cook fast enough, it could be due to using inappropriate cookware. Ensure you are using pans that are flat and match the diameter of the surface unit selected. Also, if the power (voltage) is low in your area, cover the pan with a lid until the desired heat is obtained.
What to do if the display flashes on my Samsung NE63 811 Ranges?
If the display on your Samsung Range flashes, it is likely due to a power failure. To resolve this, reset the clock.
What to do if Samsung NE63 811 Ranges oven door won't open after self-cleaning?
If your Samsung Range oven door will not open after a self-cleaning cycle, it is likely because the oven is still too hot. Allow the oven to cool down completely before attempting to open the door.
How to fix Samsung NE63 811 Ranges surface units that will not turn on?
If the surface units on your Samsung Range won't turn on, it could be due to a blown fuse or tripped circuit breaker in your home. Replace the fuse or reset the circuit breaker. Also, ensure the cooktop controls are correctly set for the surface unit you're trying to use.
Why does the display go blank on my Samsung NE63 811?
If the display on your Samsung Range goes blank, a fuse in your home may be blown, or the circuit breaker tripped. Replace the fuse or reset the circuit breaker.
Why is steam coming out of the vent of my Samsung NE63 811 Ranges?
If you see steam coming out of the vent of your Samsung Range during oven use, it is normal operation and not a system failure. Continue using the range as usual.
How to make Samsung NE63 811 Ranges oven racks slide easier?
If your Samsung Range oven racks are difficult to slide, and you have cleaned the shiny, silver-colored racks in a self-cleaning cycle, apply a small amount of vegetable oil to a paper towel, and then wipe the edges of the oven racks with the paper towel.
Why Samsung NE63 811 oven light will not turn on?
If your Samsung Range oven light will not turn on, the light bulb may be loose or defective. Try tightening or replacing the bulb. If the issue persists, the switch operating the light may be broken.
Instructions for securing the range to prevent tipping hazards.
Essential safety precautions for operating the appliance.
Guidelines for safe electrical installation and operation.
Precautions for child safety and oven operation.
Overview of the control panel and setting clock/timer.
How to set up and use various cooking modes like bake, broil, timed, and delay start.
Instructions for self-cleaning and steam cleaning the oven.
Solutions for control display errors and cooktop operational problems.
To Next Page
General