What to do if my Samsung NE63 811 Ranges displays a 'bAd LinE' error?
If the power connection is plugged in improperly, the message “bAd LinE” will appear on the display of your Samsung Range. To resolve this, ensure you reconnect the power connection properly. This should make the message disappear.
How to remove brown streaks from Samsung NE63 811 Ranges cooktop?
If you see brown streaks or specks on your Samsung Range cooktop, it's likely due to boilovers that have been cooked onto the surface. To remove them, wait until the surface cools down. Then, use a single-edge razor-blade scraper at approximately a 45° angle against the glass surface to remove the soil.
How to remove metallic sheen discoloration on Samsung Ranges cooktop?
If you see areas of discoloration with a metallic sheen on your Samsung Range cooktop, it's likely due to mineral deposits from water and food left on the surface. To remove these, use a ceramic-glass cooktop cleaning cream. Additionally, ensure you use cookware with clean, dry bottoms and clean the cooktop regularly every week with a ceramic cleaning agent.
How to level a Samsung NE63 811 Ranges?
If your Samsung Range is not level, it may be due to improper installation. Place the oven rack in the center of the oven and put a level on the oven rack. Adjust the leveling legs at the base of the range until the oven rack is level. Ensure the floor is level, strong, and stable enough to support the range. If the floor is sagging or sloping, contact a carpenter to correct the situation. Also, make sure the kitchen cabinets are properly aligned and provide sufficient room for installation.
How to fix Samsung NE63 811 Ranges surface units that will not turn on?
If the surface units on your Samsung Range won't turn on, it could be due to a blown fuse or tripped circuit breaker in your home. Replace the fuse or reset the circuit breaker. Also, ensure the cooktop controls are correctly set for the surface unit you're trying to use.
What to do if Samsung NE63 811 Ranges oven door won't open after self-cleaning?
If your Samsung Range oven door will not open after a self-cleaning cycle, it is likely because the oven is still too hot. Allow the oven to cool down completely before attempting to open the door.
What to do if the display flashes on my Samsung NE63 811 Ranges?
If the display on your Samsung Range flashes, it is likely due to a power failure. To resolve this, reset the clock.
Why Samsung NE63 811 Ranges surface units will not maintain a rolling boil?
If the surface units on your Samsung Range won't maintain a rolling boil or cook fast enough, it could be due to using inappropriate cookware. Ensure you are using pans that are flat and match the diameter of the surface unit selected. Also, if the power (voltage) is low in your area, cover the pan with a lid until the desired heat is obtained.
Why my Samsung Ranges oven will not turn on?
If your Samsung Range oven will not turn on, there are several potential causes: * The range may not be completely plugged into the electrical outlet. Ensure the electrical plug is correctly inserted into a properly grounded outlet. * A fuse in your home may be blown, or a circuit breaker may have tripped. Replace the fuse or reset the circuit breaker. * The oven may be too hot. Allow the oven to cool down. * Power outage. Check to see if the house lights will turn on. If necessary, call your local electric company for service.
Instructions for securing the range to prevent tipping hazards.
Essential safety precautions for operating the appliance.
Guidelines for safe electrical installation and operation.
Precautions for child safety and oven operation.
Overview of the control panel and setting clock/timer.
How to set up and use various cooking modes like bake, broil, timed, and delay start.
Instructions for self-cleaning and steam cleaning the oven.
Solutions for control display errors and cooktop operational problems.
To Next Page
General