126 Users Manual
Display Related
Q1 The LCD screen is too dark or too bright
A Adjust the LCD screen brightness. Use the <Fn>+< >, <Fn>+< > keys.
Q2 The screen saver disturbs screen viewing during Media Player or video file
operation.
A Unselect Tools > Options > Player > Allow screen saver during playback in the
Media Player.
Q3 In DOS mode, changing the full screen DOS mode by pressing
<ALT>+<Enter> key displays a broken image for a short period.
A The DOS mode which supports 2 Byte characters such as Korean and Japanese
runs in graphic not in text mode. In this case, a broken image may be displayed
while changing the video mode settings.
Q4 In the following cases, the screen blinks or displays noise for a short time:
(Click on the Graphics related tab, change the Resolution, change the
Display Device, remove the AC Adapter, restart the system and change the
PowerPlay level.)
A This may happen while the video driver is examining the connected device.
While detecting, any connected display devices may blink or some noise may
occur.
Q5 When I connect a projector, and change the setting to display screen image
on both the LCD and the projector by pressing <Fn>+<F4 / > keys,
screen is not displayed properly.
A Press <Fn>+<F4 / > keys once again.
Q6 The desktop momentarily appears as a broken image when zooming in or
out of the Media Player screen when Media Player is running.
A Since zooming in or out of the Media Player screen changes the screen resolution,
the desktop may momentarily appear as a 'broken image' during this operation.
To Next Page
Loading...
