Samsung NP-RV508I - Setting a Boot Password

70
Setting a Supervisor Password
A Supervisor Password is required to turn
the computer on or to start the System
Setup.
When setting a Supervisor Password, users
other than a supervisor cannot use the
computer.
1
Select the Security menu in the BIOS
Setup.
2
In the Set Supervisor Password item,
press <
Enter >.
3
Enter a password, press < Enter >, re-
enter the password for conrmation,
and press <
Enter > again. The
password can be up to 8 alphanumeric
characters. Special characters are not
allowed.
4
When a message conrming the
password conguration appears in the
[ Setup Notice ] window, press < Enter >.
The supervisor password has been set.
The supervisor password is required to
turn the computer on or to enter the
BIOS Setup.
Setting a User Password
Users can start the system with a user
password, but cannot enter the System
Setup. By doing this, you can prevent other
users from entering Setup.
Setting a Boot Password
When setting a password, you have to enter a password to use the computer or enter the
BIOS Setup.
By conguring a password, you can restrict system access to authorized users only and
protect data and les saved on the computer.
Before You Start!
 Do not lose or forget your password.
 If you have forgotten your password, contact a Samsung service center.
In this case, a service fee will be charged.