96
Shooting Functions > Flash
Reducing the red-eye eect
If the ash res when you capture a photo of a person in the dark, a red
glow may appear in the eyes. To reduce the red-eye eect, select Auto
Red-eye or Fill-in Red.
Without red-eye reduction With red-eye reduction
If the subject is too far from the camera or moves when the rst ash res, red-
eyes may not be reduced.
Adjusting the ash intensity
When the ash is on, adjust the ash intensity +/-2 levels.
To set the ash
intensity,
In Shooting mode, press [f]
ĺ
Flash
ĺ
an option
ĺ
[D]
ĺ
scroll the jog dial or press [C/F] to adjust the ash
intensity.
Back
Set
Flash : 0.0
You can also drag the slider or touch +/- to adjust the intensity.
Adjusting the flash intensity may not be eective when:
-
the subject is too close to the camera
-
you set a high ISO sensitivity
-
the exposure value is too big or too small
In some shooting modes, you cannot use this function.
If you attach an intensity-adjustable external ash to the camera, the intensity
settings of the ash will be applied.
If the subject is too close when you use the ash, some light may be blocked,
resulting in a dark photo. Ensure that the subject is within the recommended
range, which varies by lens.
When a lens hood is attached, the light from the ash can be blocked by the
hood. Remove the hood to use the ash.
To Next Page
Loading...
