Samsung PL42B450B1XZD - How to Access Service Mode

Troubleshooting
Samsung Electronics 4-19
4-2-2 How to Access Service Mode
1. General Remote
To Enter: →→→→→
(Interval between key strokes: less than 3 sec)
To Exit: →
2. Factory Remote
To Enter: →→→(Interval between key strokes: less than 3 sec)
To Exit: →
Press the Factory key twice with a key stroke interval of more than 1 second (Pressing once enters Aging Mode)
3. Settings when entering Factory mode
- Sharp Screen (Dynamic), Color Tone (Cool1), Factory (Dynamic CE Off), DNIe(Off)
4. Adjustment Procedures
- Channel ▲▼Key : Select an item.
- Volume ◀▶ Key : Adjust the value up or down.
- MENU Key : Save the changes to the EEPROM and return to the higher-level mode.
- Using the Numeric (0~9) keys, you can select a channel.
- Using the SOURCE key, you can switch AV modes.
5. Initial SERVICE MODE DISPLAY State
※ The version of the firmware displayed at the bottom of the screen may differ and the firmware is subject to change for the
improvement of product functions.
※ If you have adjusted the settings in Service Mode, you have to reset the product.
※ If you exit Service Mode without reset, DNIe vlaue keeps Off regardless of setting up the user.
STANDBY
INFO
POWER ON
POWER OFF POWER ON
POWER OFF POWER ON
POWER ON INFO FACTORY Key
Option
ADC/WB
Control
Advanced
Expert
T-STL5PAUSFC-XXXX
DTP-LP-XXXX-XX
DTP-LP-App-XXXX-XX
Option : 6110 00
ADC : HDMI O COMP O PC O AV O
EDID : SUCCESS
HDCP : SUCCESS
Build Date : XX-XX-XXXX
Date Of Purchase : XX/XX/XX
MENU
MUTE
Leandro Palmeira