Samsung PS43D490 - Initial Setup: Plug & Play; Language and Region Settings; Mode Selection: Home vs. Store; Clock and Channel Setup

English - 6
Plug & Play (Initial Setup)
When the TV is initially powered on, a sequence of on-screen prompts will assist in configuring basic settings.
Press the POWER P button. Plug & Play is available only when the Source is set to TV.
✎ Before turning on the TV, make sure the antenna cable is connected (p. 6).
✎ To return to the previous step, press the Red button.
1
Selecting a language
Press the ▲ or ▼ button, then press the ENTER
E button.
Select the desired OSD (On Screen Display) language.
2
Selecting Store
Demo or Home Use
Press the ◄ or ► button, then press the ENTER
E button.
Select the Home Use mode. Store Demo mode is for retail
environments.
To return the unit’s settings from Store Demo to Home Use
(standard): Press the volume button on the TV. When you see the
volume OSD, press and hold MENU for 5 sec.
Store Demo is only for shop display. If you select it, several
functions are not able to use. Please select Home Use when you
watch at home.
3
Selecting an area
Press the ENTER
E button. Select the appropriate area by pressing the ▲ or ▼
button.
Press the ENTER
E button to confirm your choice.
4
Setting the Clock
Press the ENTER
E button.
Select the Day, Month, Year, Hour, or Minute by pressing the ◄ or ► button.
Set the Day, Month, Year, Hour, or Minute by pressing the ▲ or ▼ button.
You can also set the Day, Month, Year, Hour and Minute by pressing the
number buttons on the remote control.
5
Memorising Channels The channel search will start automatically.
For more information, refer to Channel → Auto Tuning in the e-Manual.
6
Enjoy your TV
Press the ENTER
E button.
If You Want to Reset This Feature...
Select System - Plug & Play (Initial Setup). Enter your 4 digit PIN number. The default PIN number is “0-0-0-0.”
If you want to change the PIN number, use the Change PIN function.
You should do Plug & Play (MENU → System) again at home although you did in shop.
✎ If you forget the PIN code, press the remote control buttons in the following sequence in Standby mode,
which resets the PIN to “0-0-0-0”: MUTE → 8 → 2 → 4 → POWER (on).
P
[PD490-ASIA]BN68-03498A-01Eng.indb 6 2011-03-15 오후 2:00:34