English - 7
Plug & Play (Initial Setup)
When the TV is initially powered on, a sequence of on-screen prompts will assist in configuring basic settings.
Press the POWER
P
button. Plug & Play is available only when the Source is set to TV.
✎
Before turning on the TV, make sure the antenna cable is connected (p. 6).
1
Selecting a language
Press the ▲ or ▼ button, then press the ENTER
E
button.
Select the desired OSD (On Screen Display) language.
2
Wired/Wireless
Network Connection
Set up your network connection. Press the ENTER
E
button
to start. If you want to setting to it later, select Skip. For more
information, refer to “Wired/Wireless Network Connection” in the
e-Manual.
3
Software upgrade When network connection settings are complete, Software
Upgrade is available. Select Next to upgrade TV software. Your
TV will automatically upgrade, if your TV need a software upgrade.
If you want to upgrade later, select the Skip. For more information,
refer to "Software Upgrade" (Preference Features → Support
Menu) in the e-Manual.
✎
This may take some time, depending on network status.
4
Selecting Store
Demo or Home Use
Press the
u
or
d
button, then press the ENTER
E
button.
Select the Home Use mode. Store Demo mode is for retail environments.
To return the unit’s settings from Store Demo to Home Use (standard): Press the
volume button on the TV. When you see the volume OSD, press and hold MENU
for 5 sec.
Store Demo is only for shop display. If you select it, several functions are not able
to use. Please select Home Use when you watch at home.
5
Selecting an area
Select the appropriate area by pressing the ▲ or ▼ button.
Press the ENTER
E
button to confirm your choice.
6
Setting the Clock Set the Date and Time.
✎
You can also set the Date and Time by pressing the number buttons on the
remote control.
Press the ENTER
E
button.
7
Memorising Channels The channel search will start automatically. For more information, refer to
Channel → Auto Tuning in the e-Manual.
Enjoy your TV. If you want to watch a broadcast programme, select Close. If you want to enjoy
the Smart Hub, select the Smart Hub. The Smart Hub will start. For more
detailed information, refer to “Smart Hub” in the e-Manual.
If You Want to Reset This Feature...
Select System - Plug & Play (Initial Setup). Enter your 4 digit PIN number. The default PIN number is “0-0-0-0.”
If you want to change the PIN number, use the Change PIN function.
You should do Plug & Play (MENU → System) again at home although you did in shop.
✎
If you forget the PIN code, press the remote control buttons in the following sequence in Standby mode,
which resets the PIN to “0-0-0-0”: MUTE → 8 → 2 → 4 → POWER (on).
P
To Next Page
Loading...
