Samsung Q60A - Connecting the TV to a SBB or STB

Connecting the TV to a SBB or STB
ETH MODEM
TV Rear Panel
STB (SBB)

Connect the DATA port of the TV to the ETH MODEM
 The ETH MODEM
 
through function.
IR signal receiver specification
– Band pass filter centre frequency:  ㎑
– 
– 
– Minimum Gap Time Between the burst (tburst gap): 16 pulses (422 us)
– Minimum Gap Time between the data commands (tpause): 25 ㎳
List of Hospitality SI Vendors and compatible data cables supplied with the TV
 Confirm you are using the correct data cable for your SI vendor. Refer to the code label on the data cables.
 Contact your nearest dealer or your SI Vendor to buy the data cable not included in the TV.
1
6
1
2
3
4
5

TV side STB (SBB) side
Cable code Pin assign REMARK


TV SIDE
1: TX
2: RX
3: IR
4: NC
5: GND
STB (SBB) SIDEP1 P2
31
52
63
14
25
1: NC
2: GND
3: TX
4: NC
5: RX
6: IR
RED
GREEN
WHITE
BLACK
YELLOW
SAMSUNG and
others
 RX and TX notation is based on TV.
 
English - 27