Installing batteries into the Samsung Smart Remote
<Q85T>
1
1
2
2
1. Press the button at the top rear of the Samsung Smart Remote. The body will pop out
slightly from the body cover.
2. Turn the remote over, and then slide the body of the remote upwards until the battery
compartment is revealed.
3. If there are batteries in the remote, press the r and l buttons on both sides of the battery
compartment to remove the existing batteries.
4. Insert two new batteries (1.5V AAA type) into the battery compartment making sure that
the batteries' polarities (+, -) are oriented correctly. When done, slide the body of the
remote until it is nearly in its original position.
5. Turn the remote over, press and hold the button on the top rear, and then slide the body
of the remote down into place.
• Alkaline batteries are recommended for longer battery life.
<Q80T / Q77T / Q75T / Q74T / Q70T / Q67T / Q65T / Q64T / Q60T>
To install the batteries (1.5V AA type), push the rear cover open in the direction of the arrow at
the bottom of the illustration, and then insert the batteries as shown in the figure. Make sure
that the positive and negative ends are facing in the correct direction. Close the rear cover as
shown.
• Alkaline batteries are recommended for longer battery life.
English - 19
To Next Page
Loading...
Need help?
General
