Samsung Q8C - TV Installation; Invisible Connection Guide

01
TV
Installation
Invisible
Connection
Guide
>
To
connect the
Invisible Connection cable to the
One
Connect
and
your
TV,
take the following steps:
1.
Read
all the instructions below before
you
begin
.
2. Carefully
remove
the Invisible
Connector from its Styrofoam protector.
3.
Carefully unwind the cable (with the
[gJ
icon) from the
cable
holder of the
Invisible Connection. Unwind enough
cable
to
make
the connection between the
TV
and
the
One
Connect
Box.
- If
you
unwind the cable (with
the=
icon)
from the cable
holder,
the
cable
may
be
entangled or
damaged.
&
DO
NOT
bend
the
One
Connect
fiber
optical
cable.
Especially,
do
not
bend
the
cable
at
a
right
angle.
You
can
damage
or
break
the
cable.
The
TV
will
not
work
if
the
cable
is
broken
or
damaged.
4.
Connect the connector with the
[gJ
icon
to the
TV,
and
then connect the connector with
the=
icon
to the
One
Connect
as
shown
in
the illustration
above.
5.
Connect the
One
Connect
AC
power
cord
to the
One
Connect
and
to a power outlet
as
shown
in
the illustration
above
.
~-
When
connecting the
Invisible Connection,
use
a bending cover to prevent the
cable
of the Invisible
Connection from
being
bent at a
90
degree
angle. Failure to
do
so
may
cause
damag
e to the
cable
.
•
When
connecting the
Invisible Connection,
pay
attention to the
shapes
of
its connectors
so
that they
are
connected correctly.
Failure
to
do
so
may
cause
product malfunction.
• After connecting the
Invi
sible
Connection, wind the remaining
cable
around
the Invisible
Connec
t
ion
tube. Just winding or leaving the remaining cable
as
it
is
may
cause
damage
to the
cable.
•
When
connecting the
Invisible
Connection,
be
careful not to twist the
cable
of the Invisible
Connection.
Failure
to
do
so
may
cause
performance degradation
to
the
TV
or
damage
to the
cable
.
•
Be
careful not to take the following acti
ons
to prevent the
Invisible
Connection from being
damaged:
®
®
®
~
.
"
....
•
Bending
Twisting
Pulling Stepping
on
CLASSlLASERPRODUCT
•
Caution
-
Invisible
laser radiation when
open
.
Do
not
st
a
re
into
beam.
-
Do
not
bend
or cut
cables
ex
ce
ssively.
-
Do
not place h
ea
vy
obj
ects on the c
abl
e.
-
Do
not disassemble the connector of the cable.
Pressing
on
•
Caution
-
Use
of controls or adjustments or performance of procedures other than those specified
here
in
may
result
in
hazardou
s radiation exposur
e.
English
- 7