Samsung RB194 Series - Flooring Requirements; Refrigerator Door Removal

01 SETTING UP
Phillips Head Driver(+) Flat Head Driver(-) Socket Wrench
(10mm) (for bolts)
Hex Wrench (4.75mm)
(for Mid hinge)
Hex wrench (4mm)
(for Mid hinge shaft)
RequiredTools(Notprovided)
Some installations require door/drawer removal to transport the Refrigerator to its final location.
Do not remove the door/drawer if it is not needed. Before removing the door/drawer make sure you read
following items.
Disconnect power to the Refrigerator before remove door or drawer.
• Be careful not to drop the door and door scratch and damage while removing the door/
drawer.
• Be careful not to get injured while removing the door/drawer.
• After reattaching the door/drawer:
It is possible to have sweat by air leakage.
It is possible to have uneven door alignment.
It is possible to have more energy bills.
setting up _11
WARNING
FLOORING
For proper installation, this refrigerator must be placed
on a level surface of hard material that is the same
height as the rest of the flooring. This surface should be
strong enough to support a fully loaded refrigerator, or
approximately 106kg(223lbs). To protect the finish of the
flooring, cut a large section of the cardboard carton and
place under the refrigerator where you are working. When
moving the refrigerator, be sure to pull it straight out and
return it to position by pushing it straight in.
REMOVING THE REFRIGERATOR DOORS