To Next PageTo Next Page
Need help?Do you have a question about the Samsung RC DHXGA Series and is the answer not in the manual?
General| Brand | Samsung |
|---|---|
| Model | RC DHXGA Series |
| Category | Air Conditioner |
| Language | English |
Provides essential safety guidelines and general information for the installation and use of the air conditioner.
Details on ensuring correct power supply connections, including fuses, circuit breakers, and grounding.
Preparation details and diagrams for outdoor units of Type A, including model numbers.
Preparation details and diagrams for outdoor units of Type B, including model numbers.
Preparation details and diagrams for outdoor units of Type C, including model numbers.
Guidelines for selecting the optimal location for the outdoor unit, considering environmental factors and safety.
Details minimum clearance requirements for single outdoor units in various configurations.
Details minimum clearance requirements for multiple outdoor units in various configurations.
Details on methods for supporting the outdoor unit, including wall mounting and rack installation.
Illustrates typical wiring diagrams for single and three-phase air conditioner systems.
Details power cable specifications for single and three-phase air conditioner units.
Details connection cable specifications and terminal block specs for indoor/outdoor units.
Provides wiring diagrams for power cables and connection cords, including terminal connections.
Details the refrigerant piping system, including maximum allowable lengths and height differences.
Specifies temper grades and minimum thicknesses required for refrigerant pipes.
Lists compatible DPM models and specifies space requirements for installation.
Covers connecting communication lines, DPM operations, and setting indoor unit quantity.
Important regulatory information concerning the safe use and handling of refrigerants.
Guide on calculating the correct quantity of additional refrigerant based on installation conditions.
Lists and describes the accessories required for installing the interface module.
Details the pump down procedure specifically for relocating the air conditioner unit.
Checks for correct power supply and indoor unit connections prior to testing.
How to use outdoor unit PCB buttons (K1, K2) to run test modes (Heating, Cooling, Defrost).
Procedure to check indoor unit air treatment performance after 12 minutes of operation.
How to reset outdoor unit power supply and deactivate eco mode using the K3 button.
Details on system state information accessible via the K4 switch in View Mode.
Configuration options available through DIP switches, including auto/manual address and snow prevention.
Troubleshooting guide for the outdoor unit, detailing error codes and their meanings.
