16
A
Selecting the installation location
The following accessories are supplied with the indoor unit.
The type and quantity may differ depending on the specifications.
User & Installation
manual(1)
Pattern sheet
(1)
Insulation cover
pipe out
(2)
Insulation drain
(1)
Insulation pipe 1 (1)
I
nsulation pipe 2 (1)
Rubber
(8)
Clamp hose
(2)
Flexible hose
(1)
Cable tie
(8)
Insulation cover
drain
(1)
There must be no obstacles near the air inlet and outlet.
Install the indoor unit on a ceiling that can support its weight.
Maintain sufficient clearance around the indoor unit.
Make sure that the water dripping from the drain hose runs away correctly and safely.
The indoor unit must be installed in this way, that they are out of public access. (Not touchable by the users)
After connecting a chamber, insulate the connection part between the indoor unit and the cham-
ber with t10 or thicker insulation. Otherwise, there can be air leak or dew from the connection part.
Rigid wall without vibration.
Where it is not exposed to direct sunshine.
Where the air filter can be removed and cleaned easily.
Wired remote
control(1)
Cable-tie(2) Cable clamp(4) M4x16
tapped screw(5)
Indoor unit power
drawing cable (1)
Communication
cable of the wired
remote control (1)
Wire joint(4) User’s
manual (1)
Installation
manual (1)
To Next Page
Loading...