English 39
Installation
STEP 6 Connect the water line
You must connect a water line from the main water supply to your refrigerator to use the
water dispenser or the auto ice maker. A water lter is provided for removing unwanted
particles from the main water supply, but it does not sterilize or eliminate microorganisms
in the water, and you may need to purchase a water purifying system for that purpose.
Water pressure
The water pressure supplied to the refrigerator must meet the following requirements:
Minimum Maximum
30 psi (206 kPa) 125 psi (861 kPa)
If the refrigerator is installed in an area where minimum water pressure cannot be met,
you can install a booster pump to compensate for the low water pressure.
Connect the water supply line to the main water supply
NOTE
• Only connect the water line to potable water.
• Water line installation kits are available at extra cost from your retailer. We
recommend using a water line installation kit that contains copper tubing and a
1
/4” (6
mm) compression nut.
1. Shut off the main water supply.
2. Insert the pipe clamp (B) and the
shutoff valve (C) into the cold water
line (A).
3. Connect the water line installation kit
(A) to the shutoff valve (B).
To Next Page
Loading...
Need help?
General
