4. Remove the filter cap and insert the filter into the filter
housing.
5. Slowly turn the water filter 90° clockwise to align with the
printing mark on the cover, locking the filter in position_
Make sure to align the water filter label marl<with center of
cover filter printing as illustrated Remember, do not over-
tighten
@ Cover lilter (_
,_ ' I_
!,_! Turn unlil the label
aligned
i Separal_on
[ of red cap
_You should remove the right side upper glass shelf before installing water filters,
Removing any residual matter inside the water
supply line after installing the water filter.
1 Turn ON the main water supply & turn ©FF the valve to
the water supply line.
2., Run water through the dispenser until the water runs clear
(approx. 6°7 minutes). This will clean the water supply
system and remove air from the lines.
3. Additional flushing may be required in some households°
4, Open the Refrigerator door and make sure there are no
water leaks coming from the water filter.
[_Be sure to flush the dispenser thoroughly or water may drip from the dispenser
This is due to the fact that there is still air in the line,
Z_ Test button
c^uno_ In case ice doesn't come out, pull out the ice bucket and press test button located on the right side of ice
maker
Test button
18_ Setting Up
To Next Page
Loading...
