©peter
Controllinc ! the fridc!e temperature
The fridge temperature can be set between 46°F and 34°F to suit your particular needs. Press the Fridge button
repeatedly until the desired temperature is shown in the temperature display. The temperature will move 2°F degrees
with each press(38°F -_ 36°F -_ 34°F -_ 46°F -_ 44°F _, 42°F -_ 40°F _, 38°F). The temperature control process for
the Fridge works just like the Freezer process. Press the Fridge button to set your desired temperature. After a few
seconds, the Fridge will begin adjusting towards the newly set temperature. This will be reflected in the digital display.
Using the Power Cool
For a quick Fridge cool down, use the Power Cool function. Press and
hold the Fridge/Hold 3 sec for Power Cool button for 3 seconds. Then .................... v._o:_....
the power cool indicator will light and activate the power cool mode 0 Q
'i"_'°,s,_O_....... _°_i.......
independent of fridge set temperature. Ifyou select Power Cool, the inside
temperature of the fridge will decrease for about two and a half hours ...........
or until 25°F is reached. Press and hold the button for 3 seconds again ................................
to cancel the Power Cool mode. Then, the indicator will go out and the
Refrigerator will return to the set temperature again.
s
_- The temperature of the Freezer, fridge or Pantry Room may ...........
rise when you open the doors too frequently, or if a large _O
amount of warm or hot food is placed inside. '°"_"_°
- This may cause the digital display to blink. Once the
'_To_-
Freezer and fridge temperature return to their normal set
temperatures, the blinking will stop.
- If the blinking continues, you may need to "reset" the
Refrigerator. Try unplugging the appliance, wait for around 10 minutes and then plug the power cord
back in.
- If there is an communication error between the Display and Main Controller, the Pantry Display
light may blink. Once the normal set temperatures are reached, the blinking will stop. If the blinking
continues for a long period of time, please contact a Samsung Electronics Service Center.
USING THE COLD WATER DISPENSER
Press the Ice type or water button to select the type of you want
Using the ice Dispenser
Placea glass underneaththe ice dispenserand pushgentlyagainstthe dispenserleverwith your glass.
Makesurethe glassis in linewith the dispenserto preventthe ice from bouncingout.
\ , Before or during using, wash ice bin/bucket with a mild detergent, rinse well,
CAUTION and dry thoroughly it. Do not use harsh or abrasive cleaners or solvents.
Z_ , When Cubed Ice is selected after using the Crushed Ice mode, a small
CAUTION amount of residual crushed ice might be produced.
24 Operat qg
To Next Page
Loading...
