ASSEMBLE THE FREEZER DRAWER
Be careful not to missplace the parts of refrigerator.
ADJUSTING THE DOORS
Now that the doors are back on the Refrigerator, you want to make sure the Refrigerator is level so
that you can make final adjustments. If the Refrigerator is not level, it will not be possible to get the
doors perfectly even.
1. Pull out the rails to the full length on each side of the cabinet evenly.
2. Hang the freezer door front onto open slots on the sides.
3. Tighten four 10mm hex-head screws completely.
4. With the drawer pulled out fully, insert the lower basket (
6
) into the
rail system.
5. Hook the ends of the tilting pocket (
7
) into both brackets (
8
), and
push down until they lock into place.
6
7
8
Setting Up _11
01 SETTING UP
CAUTION
To Next Page
Loading...
