Samsung RF26DEUS - Adjusting the Freezer Drawer Level

1. If you open the drawer (
1
), you can see the lower hinge (
2
).
2. Insert the supplied hex wrench (
3
) into the shaft (
4
) of the lower hinge.
3. Please adjust the height turning the hex wrench (
3
) clockwise( ) or
counter-clockwise (
).
1
3
4
3
2
When you turn the hex wrench counter-clockwise( ), the door will move up.
4. After adjusting the doors, please insert the supplied fastener-ring (
5
) using a pair of pliers (
6
) in
the gap between the hinge-grommet (
7
) and the lower hinge(
8
). The number of fastener-rings
you’ll need to insert depends on the gap.
Two fastener-rings are enclosed with the refrigerator.
The thickness of each fastener-ring is 1mm(0.04 inch).
ADJUSTING THE FREEZER DRAWER LEVEL
Adjustment part
Freezer Drawer
1. Locate the height-adjuster (
1
) in the freezer drawer.
Unscrew the four Phillips screws (
2
) slightly to loosen the door.
2. Loosen the controller screw(
3
) with a Phillips screwdriver.
1
2
3
Setting Up _13
01 SETTING UP