3U French
USING THE COLD WATER DISPENSER
Press the Ice / Water button to select the type of you want
Using the ice Dispenser
Place a glass underneath the ice dispenser and push gently against the dispenser lever with your glass.
Make sure the glass is in line with the dispenser to prevent the ice from bouncing out.
A Please wait 2 seconds before removing the glass under the dispenser to prevent spills.
CAUTIONIf the Refrigerator door opens, the Dispenser does not work.
CAUTION
CAUTION
• When Cubed Ice is selected after using the Crushed Ice feature, a small
amount of residual crushed ice might be produced.
• Water Dispenser Installation
After installation, press the dispenser arm for at least 2 minutes to
remove trapped air from the water line and to fill the water system.
• Incase ice doesn't come out, pull out the ice bucket and press test
button located on the right side of ice maker.
Do not press the test button continuously when the tray is
filled with ice or water as illustration.
Water may overflow or ice jamming may occur.
Normal Use
To fill ice bucket to maximum capacity after installation, make sure to
do the following steps.
1. Allow your refrigerator to operate and cool down for 24 hours
(or 1 full day).
2. Waiting 24 hours will allow your ice maker to cool properly.
3. Dispense 4 to 6 ice cubes into the glass.
4. After 8 and 16 hours, dispense a full glass of ice at each time.
Check the water level
Test button
/k
CAUTION
®
24 Operat ]g
When you dump the ice from the ice bucket, you should press the
dispenser lever once with 'ICE CUBED' or 'CRUSHED' function
ON to get new ice faster after replacing the ice bucket in the refrigerator.
Whenever all ice is used at one time, the above step 3 and4 must be
repeated (before dispense the first 4 to 6 ice cubes, it needs waiting 8 hours).
This will replenish the ice cubes and ensure maximum ice production.
To Next Page
Loading...
