3-9) INSTALLATION
25
OPERATING INSTRUCTIONS & INSTALLATION
1) To protect refrigerator in movement
Use padded hand truck as shown. If entrance width is less than 39
〃
, remove doors prior to
installation and reattach doors according to procedure below.
2) Remove all protective tape and pad in refrigerators.
Connect water lines and power cord. Adjust the clearance between the doors.
3) Set the temperature control to the temperature and wait for an hour.
The refrigerator should get slightly chilled and the motor runs smoothly.
4) Once the refrigerator temperature is sufficiently low
You can store food in the refrigerator. After starting the refrigerator, it takes a few hours to
reach the appropriate temperature.
To Next Page
Loading...
