43
DISASSEMBLY AND REASSEMBLY
Part name
Ice Dispenser
& Ice Maker
How To DoDescriptive Picture
The ice maker is located inside of the
ice dispenser assembly.1.
Remove ice maker support screws
(2), and slide out.
2. Disconnect the ice maker wire
connector.
3. Unlock the locking tabs to separate
the ice maker kit.
In order to assemble the icemaker kit.
1. Assemble the geared motor shaft
and the front of ice tray.
2. Lift the front locking tab and
assemble the ice maker kit.
3.
Connect the ice maker wire connector.
4. Match the tab holes and tabs(2)
located on the top of the liner, and
slide the ice maker in.
5. Tighten the screws (2) of the ice
maker support.
5-20) ICE MAKER KIT
WIRE CONNECTOR
SUPPORT OF ICE-MAKER
FRONT OF ICE TRAY
GEARED MOTOR SHAFT
FRONT LOCKING TAB
TAB HOLES
ICE-MAKER KIT
LOCKING TAB
Part name
Ice-Maker
Thermistor
How To DoDescriptive Picture
The Ice-Maker thermistor is located in its bottom.
The temperature signal sends the micro-
processor.
5-21) ICEMAKER THERMISTOR
Thermistor
(
ICE-MAKER
)
Part name
Auger Motor
Case
How To DoDescriptive Picture
This shelf is designed to support the ice maker &
ice dispensed and Xtra Space
TM
.
1. Remove the Xtra Space
TM
cover to push it
down and pull front.
2. Slide the partition out.
3. Remove the screws (2) on the bottom front of
the case.
4. Slide out the case while disconnecting the wire
connect.
5-22) AUGER MOTOR CASE
Partition
Screws
To Next Page
Loading...
