44
5. DISASSEMBLY AND REASSEMBLY
Part name
Auger Motor
Case
Descriptive PictureHow To Do
This shelf is designed to support the ice
maker & ice dispensed and Xtra Space
TM
.
1. Remove the Xtra SpaceTM cover to push it
down and pull front.
2. Slide the partition out.
3. Remove the screws (2) on the bottom front of
the case.
4. Slide out the case while disconnecting the wire
connect.
5-21) AUGER MOTOR CASE
Partition
Screws
Part name
Freezer Light
Descriptive PictureHow To Do
The freezer light is located in the bottom of
the auger motor case. The light is covered by
an opaque cover.
1. Remove the screw and the light cover.
5-22) FREEZER LIGHT
Part name
Evaporator
Cover In
Freezer
Descriptive PictureHow To Do
1. Pull out the screw caps and remove screws
(6).
2. Remove the evaporator cover in the
direction of the arrow as shown
5-23) EVAPORATOR COVER IN FREEZER
Part name
Auger Motor
Case
Descriptive PictureDescriptive Picture
1. Remove the screw cap and screw.
2. Slide the upper fan ductwork out while
disconnecting the wire connector.
(Lamp and Thermistor)
5-24) UPPER DUCT
To Next Page
Loading...
