NO PRECEDURES HOW TO DO PICTURES
1
Put the unit on its
installation place
- under the roof, they should use rug or mat to
prevent the floor damage.
※ the installer should select a proper location.
2 Check the floor even
- If the back of the ref is not leveled, there
will be diagonal defect. So, make sure to put a
hard insertion (ex: wooden block, plastic bar) on
the lower floor, fix it with sticky tapes and
level it.
3 Insert leveling JIG
- to let the both rear caster touch the floor,
lift up a little the unit and insert the JIG.
4 Adjust the front legs - using a flat driver, let the legs touch the floor
4-1. Check the door level and adjust
4. Check the installation status
To do list
To Next Page
Loading...
