Samsung S-Box - RS232 C Connection for Setup

Samsung Electronics
13
• S-BOX Connection (RS232C) – If necessary
1. S-BOX Installation and Connection
- Connect the RS232C adapter provided on the RS232C IN terminal on the rear of the S-Box.
- If necessary, connect to PC and use it for initial network setting or debug.
※ Only one RS232C adapter is provided for a set.
※ Turn off the S-Box and connect it.
- Enter Factory mode for RS232C Read.
[Execute]
Factory remote control: i(info) → ■ (factory)
remote control : Power Off → MUTE → 1 → 8 → 2 → Power On
 Control → Sub Option → RS-232 Jack
 Change from UART to Debug.
BN39-01545B