76
Setup and Reset
6
6 Setup and Reset
6.5 Key Repeat Time
Control the response rate of a button when the button is pressed.
The functions available on the monitor may vary depending on the model. Refer to the actual product.
6.5.1 Configuring Key Repeat Time
1 When the Function Key Guide appears, select [ ] by pressing [ ] button on the DOME Type JOG
Button.
Next, press the [ ] button.
2 Press [ ] button to move to SETUP&RESET and press [ ] button on the monitor.
3 Press [ ] button to move to Key Repeat Time and press [ ] button on the monitor.
The following screen will appear.
Acceleration, 1 sec, or 2 sec can be selected. If No Repeat is selected, a command responds
only once when a button is pressed.
4 Move the focus to the desired option by pressing [ ] button on the DOME Type JOG Button.
Press [ ] button.
5 The selected option will be applied.
Off
Acceleration
Auto
Acceleration
1 sec
2 sec
No Repeat
Reset All
Eco Saving Plus
Off Timer
PC/AV Mode
Key Repeat Time
Source Detection
Power LED On
Configure the
response rate of a
button when the button
To Next Page
Loading...
