20
Installation
Attaching the Stand
―
Before assembling the product, place the product down on a flat and stable surface so that the screen is facing downwards.
Warning: The product is curved. Placing pressure on the product when on a flat surface may damage the product. When the product is on the ground facing up or down, do not put pressure on it.
1
Insert the stand neck into the stand base in the
direction shown in the figure.
2
Check that the stand neck is firmly connected.
3
Tightly fasten the connecting screw at the bottom of
the stand base.
4
Place the protective Styrofoam (cushion) included in
the package on the floor and place the product facing
down on the Styrofoam, as shown in the image.
If Styrofoam is unavailable, use a thick sitting mat.
5
Hold the main body of the product with your hand as
shown by the figure. Push the assembled stand into the
main body in the direction of the arrow as shown in the
figure.
To Next Page
Loading...
