9
Installation
Attaching the Stand
―
Before assembling the product, place the product down on a flat and stable surface so that the screen is facing downwards.
―
Disassembly is the reverse order of assembly.
x 2
1
2
Put the stand base onto the stand neck as
the direction shown in the figure. Check
that the stand neck is firmly connected.
Tightly fasten the connecting screw at the
bottom of the stand base.
3
4
Place a soft cloth over the table to protect the product and place
the product onto the cloth so that the front of the product is
facing downwards. Push the assembled stand into the main
body in the direction of the arrow as shown in the figure. Tightly
fasten the connecting screw at the bottom of the main body.
Stand assembly is complete. Caution
Do not arbitrarily remove the panel film.
If not observed, the warranty service
may be restricted.
Preparations
Chapter 02
To Next Page
Loading...
