Select the preset number.
Select <POSITION> and adjust <PAN/
TILT/ZOOM
> to the desired setup using
the joystick.
Set <PRESET ID> to <ON> and enter the
name.
For entering the name, refer to “CAMERA ID”.
(page 24)
Select <PRESET SPEED> and adjust the
pan/tilt speed of the preset.
Set the <DWELL TIME> that defines the
camera's hold duration and <IMAGE HOLD> of the preset.
If you set the <IMAGE HOLD> to <ON>, the video image will be held still until the
camera reaches the preset position.
Set <CAMERA SET> to <ON>.
You can adjust camera setups for each
preset.
For details on setting <IRIS>, <WHITE BAL>
and <FOCUS MODE>, refer to “CAMERA
SET”. (pages 24 ~ 32)
The preset position can be specified for a
tilt range of between 0° and 90°.
Those presets that are out of a tilt of 90° can not be specified.
If you try to specify a preset position for a range exceeding a tilt of 90° using a
controller (SSC-1000, 2000 or 5000), you will see a message of <SET AGAIN> on
the screen. If this is the case, try again for a range below a tilt of 90°.
If you upload/download the menu setting using SSC-1000, 2000 or 5000, the preset
may differ from the menu setting so define the preset again after the operation.
2.
3.
4.
5.
6.
7.
M
PRESET
0 1 2 3 4
5 6 7 8 9
10 11 12 13 14
15 16 17 18 19
20 21 22 23 24
25 26 27 28 29
30 31
1/16
PRESET NO. 1
POSITION
PRESET ID ON
PRESET SPEED [
5
]
DWELL TIME 3SEC
IMAGE HOLD OFF
CAMERA SET ON
CAMERA SET
IRIS ALC
WHITE BAL
FOCUS MODE MF
To Next Page
Loading...
