English - 21
● CONNECTION & INSTALLATION
HOW TO SET UP PROTOCOLS AND ID DIP SWITCHES
You can control various settings of the camera system using the Communication and ID DIP switches.
Before installing the product, please set up the DIP switches according to the installation environment.
Detach the camera frame from the install base, and place the bottom of the frame toward you as shown in the
picture below.
Set the switches according to your installation environment. For more detailed setup information, please refer
to the chart on the next page.
The camera may malfunction if the switches are not fully turned On/Off; please double check the switches
before fi nishing setup.
Communication Protocol DIP Switch(SW2)
Camera ID DIP Switch(SW1)
1.
2.
3.
To Next Page
Loading...
